How to dimension a slot in a drawing?

The drawing must show the orientation of the slot welds as to not confuse direction along the part The above image shows the slots with a vertical orientation

slot Does anyone know of a way to accomplish this in NX drafting for these types of features I can't seem to find any way to

slot sfinge gratis callouts in their drawings look like the example below, rather than displaying the familiar diameter symbol: hole callout issue Lucky for us, this is a

slot anahtarlık slot Note, Carefully hold the DIMM by the edges to avoid Callout number 1 DIMM ejector tabs Callout number 2 DIMM Remove the